sh ip int biref displays nothing!

Guest · Posted: Mon Apr 24, 2006 7:37 pm Post subject: sh ip int biref displays nothing!

I have a C2950 that when I do a sh ip int brief and then a sh ip int
fastethernet x/x (where x/x is one of the interfaces shown as up), I
just get an empty return.For example:

SW#sh ip int fastEthernet 0/6

SW#sh ip int fastEthernet 0/3

SW#sh ip int fastEthernet 0/2

SW#sh ip int fastEthernet 0/4

Has anyone ever seen this? CPU utilization is not high (1-2%).

Thanks

Merv · Guest

The 2950 is a layer 2 switch.

The available show interrface related commands are :
show interface
show interfaces counters
show interfaces status
show interfaces switchport
show interfaces trunk

closest to sh ip int brief would probably be sh int status

Guest

This command is going to show Layer 3 IP info about the interface. On
a switch, IP Routing is disabled by default. And typically IP routing
is done on a VLAN interface rather than a FastEthernet interface. Try
"ip routing" globally, configure IP on an interface, and then "show ip
interface". Like "show i p interface vlan1"

Steve Griffin
www.blueconsole.com (Bluetooth Wireless Console Cable)